MCZ Gaudi User Manual
Page 25
INSTALLATION AND USE MANUAL
Chapter 3
GAUDI’
pag.
25
Chapter 3
Technical service – all rights reserved by mcz spa
Reproduction prohibited
3.12. PHASE 7 - “GAUDI’ WITH COMPARTMENT" - ASSEMBLY OF FIREBED
(elements 5, 6 and 7)
LATO CARICAMENTO FORMA PUROB95
LATO SERVIZIO FORMA PUROB95
SUPPORTO
NON A VISTA
SPALLA
RIVESTIMENTO
A VISTA
SUPPORTO
NON A VISTA
SPALLA
RIVESTIMENTO
A VISTA
Before proceeding with final assembly of the firebed, you should first dry test the installation, and then proceed
with final installation. If necessary, use the feet of the Forma PuroB95 for precision adjustment of the height of
the unit.
Place the two
side elements (rh and lh) of the firebed under the edge-cover profiles and under the compartment
base (in the direction shown in the figure). Correct their position so that the part that protrudes from the front is
aligned with the visible
cladding side. If necessary, provide temporary supports for the two elements. The edge-
cover profiles and the compartment base must rest on the firebed.
Place the
centre element of the firebed under the visible cladding side. Make sure that it is in contact with the
side elements (rh and lh) and aligned with the
cladding side itself (see the figure on the next page). Use marble
cement to fasten the three marble elements.