MCZ Gaudi - Manual (Page 16)

INSTALLATION AND USE MANUAL Chapter 3
GAUDI’ pag. 16
Chapter 3 Technical service – all rights reserved by mcz spa
Reproduction prohibited
3.7. PHASE 6 - “GAUDI’ WITHOUT COMPARTMENT”– ASSEMBLY OF FIREBED
(elements 4, 5 and 6)
LATO CARICAMENTO FORMA PUROB95
LATO SERVIZIO FORMA PUROB95
SPALLA RIVESTIMENTO
A VISTA
SUPPORTO
NON A VISTA
SUPPORTO
NON A VISTA
SPALLA RIVESTIMENTO
A VISTA
Before proceeding with final assembly of the firebed, you should first dry test the installation, and then proceed
with final installation. If necessary, use the feet of the Forma PuroB95 for precision adjustment of the height of
the unit.
Place the two
side elements (rh and lh) of the firebed under the edge-cover profiles (in the direction shown in
the figure). Correct their position so that the part that protrudes from the front is aligned with the visible cladding
side. If necessary, provide temporary supports for the two elements. The edge-cover profiles must rest on the
firebed.