MCZ FC700-715 - 180+180 m3/h - Manual (Page 16)

Chapter 5
INSTALLATION AND USE MANUAL
page
16
Operation Technical service – MCZ S.p.A. all rights reserved - Reproduction prohibited
It may however be necessary to change this code, and as a result the
transmission frequency, if another fireplace stove is located nearby
(e.g. if your neighbour has one) or if other signals interfere with
transmission.
The code can be personalized as follows:
• Unplug the control unit
• Open the battery compartment of the radio remote control by
moving the cover in the direction of the arrow (Figure 20)
• Raise any one, or more than one, of the 10 white keys as
shown in the example in figure 21.
• Close the radio remote control
• Press and hold the red key of the radio remote control, and at
the same time plug it back in.
• After a maximum of 15 seconds, a prolonged beep or a series
of beeps in sequence confirm that the radio remote control has
been connected to the control unit with the new code.
Figure 20 – Switch in battery compartment of
radio remote control
Figure 21 – Example of variation of code
BATTERY COMPARTMENT
AND SWITCH
ON
OFF
MAN
AUT