Epson Expression 1680 - Manual (Page 18)

Expression 1680/1680 Pro
A5-Format Quick Start Manual_E.fm
3/6/01 Left page
L
18
■
Connecting the scanner
Connect the scanner to your computer or to another SCSI device as described below.
Note:
The types of connectors needed on the SCSI interface cable varies depending on the
maker of your SCSI device and SCSI interface board.
1. Make sure the scanner, computer, and all other SCSI devices are turned off and
unplugged from the power source.
c
Caution:
Do not connect the scanner to the computer or other devices while they
are turned on as damage may occur.
2. Connect one end of the interface cable to one of the scanner SCSI connectors until
the locks on both sides snap in.
Note:
❏
To connect the scanner to a SCSI device other than the computer, the length
of cable in the daisy chain must not exceed 6 meters; otherwise the system
may not work properly.
❏
To connect the scanner to a PC using SCSI-2, the length of the cable must
not exceed 3 meters.
❏
Make sure no other interface is used.
3. Connect the other end of the cable to the SCSI port of your computer or another
SCSI device.
Note:
The SCSI port on the Macintosh is the larger port with the SCSI icon over it.
4. Plug in the power cords of your computer, scanner, and other external SCSI devices.
Note:
Before turning on your system, be sure to read “Power-on sequence” following.