Visual setup menu, P. 58, Image page option page info page – Epson EMP-TWD10 User Manual
Page 60

58
Image page
Option page
Info page
Setting Item
Setting Contents
Brightness
Adjusts the image brightness.
Contrast
Adjusts the difference between light and shade in the images.
Color Saturation
Adjusts the color saturation for the images. (This is not displayed
when a computer is connected.)
Tint
Adjusts the image tint. (This is not displayed when the external
video or computer connected is not NTSC.)
Sharpness
Adjusts the image sharpness.
Progressive
Converts the interlace signals into progressive
signals appropriate to the current picture.
Can only be set when one of the following eight signals is input:
HDMI input terminal, 480i, 576i and 1080i in component video,
NTSC and PAL in S-video, or NTSC and PAL in composite video.
Off: Suitable for fast action images.
Video: Suitable for ordinary video images.
Film/Auto: Uses 2-3 pull-down mode and converts 24/30-frame
movie film, CG and animation images into appropriate
progressive signals to produce natural image quality.
Setting Item
Setting Contents
Video Signal
Sets the signal format of the video equipment
connected to the Video input port or the S-
Video input port.
Only displayed when “Video” is selected as the source.
At the time of purchase, this is set to “Auto” so the video signal is
recognized automatically. If interference appears in the projected
images or no images appear when you select “Auto”, select the
appropriate signal manually.
Child Lock
Use
on the main unit to lock the power-
on.
On:
Starts the Child Lock. To turn the power supply on, hold
down
on the main unit for approximately 5 seconds or
hold down
on the remote control.
Off: Cancels the Child Lock.
High Altitude Mode
Set this mode when you use this unit at high
altitudes.
When using this unit at high altitudes, that is 1500 meters or more
above sea level, turn this mode “On”.
Item
Contents
Information
Displays the
current status.
Lamp Hours: Total usage time of the lamp. 0H is displayed for 0 to 10 hours. Changes to units of
1 hour at 10 hours and above. The display turns yellow text when it is time to
change the lamp.
Source:
Displays whether standard DVD player images are being projected, or images from
external video equipment or a computer are being projected.
Video Signal:This is displayed when “Video” is selected as the “Source”, and displays the format
of the video signal being input.
Resolution:
The resolution is displayed if the “Source” is other than “Video”. The resolution of
image signals from a computer and the component video signals that are being
input are displayed.
Status:
Displays any error information. You may be asked for this information when you
contact your service center.
Reset Lamp
Hours
After you have replaced the unit lamp, initialize the lamp hour settings. The accumulated lamp
operating time is cleared.
Visual Setup menu