Cleaning, Storage – Silvercrest SKG 1700 A1 User Manual
Page 64

62 GB
Grill oven (Figure C)
The oven function is particularly suitable for
the gratinating of food.
1. Preheat the grill plates12.
2. Open the lid4 of the contact grill up-
wards. Be careful not to raise the lid
any further after it is vertical.
3. Place the food to be grilled on the lower
grill plate.
4. Lift the lid4 up and pull it forwards and
down, until it is parallel to the lower grill
plate12.
6.4 Switching off
1. Set both thermostat controls9 +14 to
the setting "•".
2. Pull out the mains plug6.
3. Lift the grilled food off the grill plate12
using a suitable kitchen utensil. Use e.g.
a spatula made from wood or heat-re-
sistant plastic, but never from metal.
7. Cleaning
Clean the device prior to its first use!
DANGER! Risk of electric
shock!
• Pull the mains plug6 out of the wall
socket before you clean the contact grill.
• The device, the power cable
and the mains
plug6 must not be immersed in water or
any other liquids.
DANGER! Risk of injury
through burning!
Allow all the parts to cool down be-
fore cleaning.
WARNING! Risk of material damage!
Do not use any astringent or abrasive clean-
ing agents.
Clean the device after each use and remove
all food residues.
Outer surfaces
• Clean the outer surfaces using a soft,
damp cloth with a mild soap solution.
Grill plates
For purposes of cleaning, remove the grill
plates12 from the device after it has cooled
down.
1. Press the grip clamps5 to the side and
remove the grill plates12 from their
brackets.
2. Clean the grill plates12 using mild de-
tergent and dry them.
3. Place the grill plates into the device and
press them against the grip clamps5
until the grill plates click into position.
NOTE: burnt-on food or fat residue is often
easier to remove if you leave a damp wash-
cloth on the baked-on residue overnight to
soften it.
8. Storage
DANGER for children!
Keep the contact grill out of the
reach of children.
• Clean all parts, and allow them to dry
properly before you put the contact grill
away.
• Figure D: wind the power cable6
around the cable spool7 when the de-
vice is upright.
• Select a location where neither high
temperatures nor moisture can affect the
device.
__RP90859_B1.book Seite 62 Montag, 26. August 2013 1:16 13