Extron electronic Dual Link DVI Transmitter and Receiver DVI DL 201 Tx - Manual (Page 17)

DVI DL 201 Tx/Rx • Installation 2-5
Through-desk mounting
The DVI DL 201 Tx should not be mounted through a desk.
To mount the DVI DL 201 Rx through a desk or podium, use
the optional Extron MBD 129 through-desk mounting kit
(PN 70-077-02), and follow these instructions:
1
. Remove rubber feet if these have been installed on the
bottom of the unit.
2 . Attach the brackets to the receiver, using the four 4-40
screws provided; leave the screws slightly loose.
Through-desk mounting the DVI DL 201 Rx
3 . Hold the unit in position under the mounting surface.
Mark the location of the four screw holes and the
mounting hole to be cut in the table.
4 . Cut away the table material. Test the fit by inserting the
front of the device through the hole. If necessary, use a
rasp or coarse file to enlarge the hole.
5 . Hold the receiver, with the brackets attached, in position
and mark the location of the holes in the brackets. Drill
four pilot holes, each 3/32" (2 mm) in diameter by 1/4"
deep (6.3 mm) deep.
6 . Attach the brackets to the mounting surface, using the four
#8 wood screws provided with the kit.
7 . Slide the device in or out until the front panel is flush with
the table surface. Tighten the screws installed in step 2.
8 . If the screws are inaccessible to a screwdriver, mark the
location of the unit relative to the brackets, remove the unit
and brackets, tighten the screws holding the brackets and
replace the unit as described in step 6.