Enterasys Networks SecureStack C2RPS-CHAS2 - Manual (Page 25)

Installing C2RPS-PSMs
SecureStack C2 Installation Guide 2-3
Figure 2-1 C2RPS-PSM Installation
Replacing an Installed C2RPS-PSM
To replace a PSM installed in an operating system, proceed as follows:
1. Unplug the AC power cord of the PSM from the AC power source first, then from the
rear of the PSM.
2. Loosen the captive screws securing the PSM until it is released from the chassis front
panel.
3. Pull the PSM out and remove it from the chassis.
4. Repeat steps 1 through 3 for each additional PSM you plan to remove.
1 C2RPS-CHAS2 chassis 3 Chassis power supply slot
2 C2RPS-PSM power supply module 4 Captive screws (2)
C2RPS-CHAS2
C2RPS-PSM
Pow er
Г
Г
А
В Б
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.