Enterasys Networks SecureStack C2RPS-CHAS2 - Manual (Page 24)

Installing C2RPS-PSMs
2-2 Installation
3. Perform a visual inspection of the switch devices for any signs of physical damage.
Contact Enterasys Networks if there are any signs of damage. Refer to “
Getting Help ”
on page 1‐5 for details.
Installing C2RPS-PSMs
When you receive your C2RPS‐CHAS2 chassis, a coverplate will be in place over each
power‐supply slot.
To install the PSMs, refer to Figure 2‐1 and proceed as follows:
1. Place the chassis on a sturdy flat surface where you plan to install PSM s .
2. Align the PSM with one of the slots, then slide the PSM forward until its front panel is
flush against the chassis front panel.
3. Fasten the PSM to the chassis using the captive screws on the PSM front panel.
4. Repeat steps 2 and 3 for each additional PSM.
5. Proceed to “ Installing C2RPS‐CHAS2 into the Rack ” on page 2‐4 for the rack mount
installation instructions.
Table 2-1 Contents of C2RPS-CHAS2 Carton
Item Quantity
C2RPS-CHAS2 1
This guide, SecureStack C2 Installation Guide (9034091-xx) 1
Release Notes 1
Table 2-2 Contents of C2RPS-PSM Carton
Item Quantity
C2RPS-PSM 150 Watt DC Power Supply Module 1
USA, NEMA Power Cord 1
C2RPS-PSM Cable 1
Notice Card 1
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.