Extron electronic P/2 DA6xi - Manual (Page 5)

P/2 DA4xi/6xi • Installation P/2 DA4xi/6xi • Installation
P/2 DA4xi and P/2 DA6xi, cont’d
1 Power LED : A green LED indicates that the distribution
amplifier is receiving power.
Rear panel features
100-240V 0.2A
INPUT
P/2 DA6xi
VIDEO GAIN 1V
.7V
3
(LOCAL MONITOR)
2
1 3 5
4 6
OUTPUTS 50/60 Hz
100-240V 0.2A
INPUT
P/2 DA4xi
VIDEO GAIN 1V
.7V
3
(LOCAL MONITOR)
2
1 3
4
OUTPUTS 50/60 Hz
P/2 DA4xi
P/2 DA6xi
1 2
3 4 5
1 Power LED — A green LED indicates that the distribution
amplifier is receiving power.
2 Video Gain sliding switch — Used for installations with long
output cable runs, the 1.0 V (up) position gives a brighter
picture. The default Video Gain setting is 0.7 V (down).
3 Input Connector — Connect the input cable (using VGA-UXGA
signals) to the DA’s 15-pin HD female connector.
4 Local Monitor — Connect a local monitor to this 15-pin HD
female connector for loop-through capability.
5 Output Connector — Connect the output device to the 15-pin
HD female connector.
Operation
After the distribution amplifier and its connected devices are
powered up, the system is fully operational. If any problems
occur, verify that the cables are properly routed and connected.
Signal input and output connections
All connections, including power, input, and output are located
on the back of the rear panel of the P/2 DA4xi and P/2 DA6xi.
VGA DISTRIB UTION AMPLI
FIER
3. Hold the unit against the underside of the surface through
which it will be mounted. Mark the four screw holes on
the underside of the surface to which you are mounting
the device.
4. Drill four pilot holes, each 3/32" in diameter by 1/4" deep,
where you made marks.
5. Using the four wood screws provided, attach the brackets
to the mounting surface.
6. Slide the unit up and down or back and forth in the
mounting brackets until the face of the unit is at the
desired height. Tighten the screws that secure the bracket
in place.
a. Mark the location of the brackets relative to the
screws.
b. Remove the unit from the underside of the surface.
c. Tighten the screws.
d. Replace the switcher on the underside of the surface
(step 5).
Front panel indicators
VGA DISTRIBUTION AMPLIFIER
1
5 4 P/2 DA4xi/6xi • Operation