Extron electronic ISM 482 - Manual (Page 93)

Ethernet Connection, cont’d
Integration Scaling Matrix Switcher • Ethernet Connection A-4
Connecting as a Telnet Client
The Microsoft Telnet utility is available from the DOS prompt. Telnet allows you to
input SIS commands to the ISM from the PC via Ethernet.
Access the DOS prompt and start Telnet as follows:
1 . Click Start > Run.
2 . At the Open prompt, type command.
3 . Click the OK button.
4 . At the DOS prompt, type telnet and press
Enter
. The computer returns a
display similar to figure A-3.
Microsoft (R) windows 2000 (TM) Version 5.0 (Build 2195)
Welcome to Microsoft Telnet Client
Telnet Client Build 5.00.99203.1
Escape Character is 'CTRL+]'
Microsoft Telnet>
Figure A-3 — Telnet screen
Telnet tips
It is not the intention of this manual to detail all of the operations and functionality
of Telnet; however, some basic level of understanding is necessary for operating the
ISS via Telnet.
Open
Connect to the ISM using the Open command. Once you are connected to the
switcher, you can enter the SIS commands the same way that you would if you
were using the RS-232 link.
Connect to the ISM as follows:
1 . At the Telnet prompt, type open {IP address} and then press
Enter
.
If the switcher is not password protected , no further prompts are displayed
until you break or disconnect the connection to the ISM.
If the switcher is password protected , Telnet displays the password prompt.
2 . If necessary, at the password prompt, type the appropriate password and then
press
Enter .
Connection to the switcher via the Ethernet can be password protected. There
are two levels of password protection: administrator and user. A person
logged on as an administrator has full access to all ISM switching capabilities
and editing functions. Users can select video and/or audio for output, select
test patterns, set RGB and audio mutes, select a blue screen, and view all
settings with the exception of passwords. By default, the ISM is shipped with
no password assigned.