Ericsson GH198 - Manual (Page 25)

When an underline character ( _ ) appears to the
right of the letter entered, you can enter the next.
You can enter up to eight letters.
● If you want to enter a digit
(0 -- 9) instead of a letter, press the appropriate
numeric key four times.
● If you want a space, press the * (Star) key
once. Pressing * twice, enters a star.
● If you want a hyphen (-), press the # (Hash)
key once. Pressing # twice, enters a hash.
● If you make a mistake, correct it with the C key.
7. When you have entered the entire name, press S.
‘‘STORED’’ is displayed. The number and name is
stored. The display returns to normal.
If you do not press S, the number and name will be
stored automatically after about 20 seconds.
If you change your mind and do not wish to store
the number and name, press and hold down C
within these 20 seconds.
If you do not wish to enter a name, press S when
the question ‘‘NAME?’’ appears. The number will
then be stored without a name.
Memory Protection
If you try to store a number in a memory location which
already contains a number, the message ‘‘USED’’ flashes
in the display for five seconds.
You can then choose either to:
a. Store the number in a different memory location.
Enter the number of this memory location and
press S.
b. Store the number under the selected memory
location, thus
erasing the old number (and name). Just press S.
Memory Full
If, when you attempt to store a new number, all memory
locations are in use, ‘‘STORE LOC?’’ is displayed.
If you do not wish to store the number, press C.
If, on the other hand, you do wish to store the number, you
can do one of the following:
a. Store the number temporarily in the dialling
memory. Press # (Hash). ‘‘STORED DM’’ is
displayed. See also the chapter Dialling Memory.
b. Store the number in an already occupied memory
location, thus erasing the old number (and name).
Enter the required memory location number and
press S.
Storing Numbers
20