Silvercrest SKRD 30 A1 - Manual (Page 21)

19
Handling and operation
SKRD 30 A1
GB
IE
CY
The Reminder function
The device will remind you of the date that you have set with the memory function.
A signal tone sounds at the set time for 10 minutes every hour and it blinks
in the display 3 .
Press any button to end the signal tone. ♦
Radio operation
NOTICE
For a good radio reception the wire antenna ►
15
must be completely un-
coiled. Adjust the antenna, whilst in radio operation, to the best reception.
The technical factors of the device allow for tuning reception frequencies
►
outside of the permitted VHF (FM) range of 87.5–108 MHz. In some
countries, diff erent national regulations may apply to the assigned radio
frequency ranges.
Please note that information received outside of the assigned radio
frequency ranges may not be exploited, passed on to third parties or
otherwise misused.
Switching the radio on/off
Switch the radio on by pressing the On/Off ♦ 4 button.The display 3
shows the current reception frequency of the tuned station.
Switch the radio off by pressing the On/Off ♦ 4 button again.The device
changes back to the operational mode clock/standby operation. The cur-
rent time of day is shown.
Adjusting the volume.
With the VOLUME ♦ 14 knob set the desired volume. Turning in a clockwise
direction increases the volume; turning in a counter clockwise direction
reduces the volume. The volume level is shown on the left border of the
display
3 .
Manual station selection
By a single press on the buttons Tune+ ♦
13
and Tune– 12 tune the desired
station. The frequency of the station is shown in the display 3 . During the
tuning the speaker is switched off .