Before using for the first time, Operation, 1 preparing the appliance – Silvercrest SRGS 1300 A2 User Manual
Page 10
8
5. Before using for the first time
During manufacture, many parts are given a
thin film of protective oil. Before using the
appliance for the first time, heat it up without
any food so that any residues can
evaporate.
Note:
When heating up for the first few
times a slight smell may be produced. Make
sure the room is adequately ventilated.
1. Take the appliance and all the accessory
parts out of the packaging.
2. Check that the appliance shows no signs
of damage.
3. Remove any labels or stickers (but
not
the type plate on the underside).
4. Clean the appliance before using it for
the first time. Observe the information in
the section entitled "7. Cleaning" on
page 10.
5. Select a location that is firm, level and
not flammable. Maintain a distance of
approx. 50 cm from other objects.
6. Turn the temperature regulator
5
to "0".
This switches the appliance off.
7. Plug the mains plug into a suitable mains
socket that corresponds to the technical
data.
8. Turn the temperature regulator
5
to
MAX
.
The indicator lamp
3
lights up and the
appliance heats up.
9. Leave the appliance switched on for
around 10 - 15 minutes.
10. Switch the appliance off by turning the
temperature regulator
5
to "0".
11. Take out the mains plug and allow the
appliance to cool down.
12. Clean the appliance again. Observe the
information in the section entitled
"7. Cleaning" on page 10.
6. Operation
6.1 Preparing the appliance
1. Select a location that is firm, level and
not flammable. Maintain a distance of
approx. 50 cm from other objects.
2. Turn the temperature regulator
5
to "0".
This switches the appliance off.
3. Grease the raclette pans lightly
7
on the
inside.
Note:
Use kitchen paper dipped in a
little cooking oil.
4. Lightly grease the top surface of the
stone grill plate
1
and grill plate
2
.
Note:
Do not use too much oil as this
could catch fire and burn. Spread the oil
carefully using a cooking brush or
kitchen paper.
5. Place the stone grill plate
1
and grill
plate
2
on the appliance.
Note:
The grooves on the stone grill
plate
1
must face up. The grill plate
2
can be used on both sides.
6. Plug the mains plug into a suitable mains
socket that corresponds to the technical
data.
7. Turn the temperature regulator
5
clockwise to
MAX
.
RP75604 Raclette hs LB4 Seite 8 Donnerstag, 19. Juli 2012 9:56 09