Silvercrest SKMP 1200 A2 - Manual (Page 61)

SKMP 1200 A2 59
4.6 For the safety of your child
Warning! Children are often
unaware of danger and are injured
as a result. Please note therefore:
• Ensure that the packing foil does not
become a deadly trap for a child.
Packing foils are not toys.
4.7 Material damage
Warning! Follow the instructions given
below to prevent material damage.
• Only place the appliance on a level,
dry, non-slip surface to stop the appli-
ance falling over or sliding off.
• Do not place the appliance on top of a
hot stove.
• Do not use the blender jug 12 and the
mixing bowl 16 at the same time. This
might overload the appliance.
• Never use the mixer and the blender
jug 12 when empty. This might cause
the motor to overheat.
• The mixer should only ever be operated
for max. 10 minutes at a time, and the
blender for 3 minutes. Afterwards the
appliance must be first allowed to cool
down to roomtemperature again.
• Only ever use the blender jug 12 with
the lid in place 11 as liquid might other-
wise be ejected.
• Do not move the appliance if food or
pastry is still inside.
• Only use the blender jug 12 to mix
drinks or make dressings.
• Do not overfill the mixing bowl 16 or
blender jug 12 as the contents might
otherwise be ejected.
• Never add hot or boiling food to the
blender jug 12.
5. Unpacking and setting up
1. Remove the individual parts from the
packaging.
2. Check that the individual parts are
complete (see “1.2 Scope of supply” on
page 55) and are undamaged.
3. Clean the appliance thoroughly before
using it for the first time (see
“8. Cleaning the appliance” on
page 68).
4. Place the appliance on a level, dry, non-
slip surface so that the appliance can
neither fall over nor slide off.
5. Check that the speed controller 4 is set
to "0".
6. Put the plug in a suitable socket (see
“3. Technical data” on page 56).
The appliance is now ready to use.
6. Operating the appliance
6.1 Assembling the appliance
1. Press the unlock lever 6 and swing up
the drive arm 1.
Note: Press the unlock lever 6 round
fully and hold until the drive arm 1 is
right down. Then swing the unlock
lever 6 back again.
RP100104-105590 Küchenmaschine LB2 Seite 59 Donnerstag, 12. Juni 2014 12:25 12