Sealey VS1815 - Manual (Page 2)

3.1.2. slide the pressure plate onto the bearing setting bar allowing it to click into one of it's positions. then push
the assembly up through the headstock, bearing race and die. Wind the winding handle onto the bar and
re-adjust the pressure plate to the correct setting (fig.3.2).
3.1.3. Wind the winding handle so that the bearing race is pushed into the headstock. When in place release the
pressure plate (fig3.3).
3.2. Bottom Bearing Race Insertion
3.2.1. Position bottom bearing race in headstock and select appropriate size die, one which is slightly smaller
than the diameter of the bearing race.
3.2.2. slide the pressure plate onto the bearing setting bar, allowing it to click into one of it's positions (fig.3.4.).
continue to wind the winding handle onto the bar so that the bearing race is pushed into the headstock
(fig.3.5). When in place release the pressure plate and remove the assembly from the headstock.
3.2.3. to ensure that both bearing races are fully driven home, place the die onto the die handle, position it
over the bearing race and using a soft faced hammer, drive the bearing race home. return all parts to
the case, and store in a safe, dry, childproof location.
4. PARTS
ALWAYS WEAR SAFETY GOGGLES WHEN USING DRIVERS
Users of drivers are reminded that damage to the striking faces can take place and we
recommend that safety goggles are worn when using this tool.
Vs1815.01 WInDInG HAnDLE
Vs1815.02 WInDInG HAnDLE KnoB
Vs1815.03 nYLon WAsHEr
Vs1815.04 MoVEABLE PLAtE
Vs1815.05 cIrcLIP
Vs1815.06-1 DIE, 32mm
Vs1815.06-2 DIE, 36mm
Vs1815.06-3 DIE, 38mm
Vs1815.06-4 DIE, 42mm
Vs1815.06-5 DIE, 46mm
Vs1815.07 sLIDInG LEVEr (PrEss. PLAtE)
Vs1815.08 sPLIt PIn
Vs1815.09 sPrInG
Vs1815.10 sLIDInG PrEssurE PLAtE
Vs1815.11 sEttInG BAr
Vs1815.12 DIE DrIVInG HAnDLE
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park ,
Bury st. Edmunds, suffolk,
IP32 7Ar
www.sealey.co.uk
Web
email
Original Language Version
Vs1815 Issue: 1 - 12/05/10
fig.3
1 2 3
4 5