Sealey MS079 User Manual
Safety instructions, Introduction & specification, Maintenance
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
Quick and easy to use. Simply hook into the rear axle. Available to use for motorcycles with rear axle inner diameters of 11mm,
14.5mm and18mm. When needing to move the motorcycle, un-hook the stand off the axle and place onto the footpeg for future use.
2. INTRODUCTION & SpECIFICATION
DO NOT sit on a motorcycle when it is on a stand.
DO NOT start a motorcycle on a stand.
DO NOT use the stand for a purpose it is not designed to perform.
DO NOT use the stand if it is damaged.
DO NOT make any modifications to the stand.
DO NOT mount the stand on tarmacadam, as the surface may be unstable.
Use only as a convenient but temporary stand.
Maintain the
stand in a good clean condition for the best and safest performance.
Locate the stand and motorcycle in a suitable area.
Ensure that the floor is not slippery, wear non-slip footwear.
Keep children and unauthorised persons away from the parked area.
When not in use, store in a safe, dry, childproof location.
IMPORTANT: pLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OpERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE pRODUCT CORRECTLY AND WITH CARE FOR THE pURpOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR pERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. pLEASE KEEp INSTRUCTIONS SAFE FOR FUTURE USE.
Original Language Version
MS079 Issue: 1 - 06/02/13
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMpORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
© Jack Sealey Limited 2013
INSTRUCTIONS FOR:
TRIANGLE DIRTBIKE STAND
MODEL No:
MS079
Environmental protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
Stand elevations, side and end
4. MAINTENANCE
4.1
Check visually the integrity of the welds.
4.2. Keep the stand clean and wipe off any oil or grease.
4.3. When the stand is not in use, store it in a safe, dry, childproof location.
Specification.
Model No: ..................................................................... MS079
Axle Diameters: ....................................11mm, 14.5mm, 18mm
3. OpERATION INSTRUCTIONS
3.1
Offer
the stand spigot into the rear axle fully and lean the motor cycle until the triangle base engages with the deck.
3.2
Continue to control and lean the motorcycle until the full load is supported.
Spigot