Sealey MS063 - Manual

InstructIons for:
Motorcycle Dolly - Side Stand Type
MoDEL no:
MS063
thank you for purchasing a sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
2. INTRODUCTION/SPECIFICATION

Maintain the dolly in good condition (use an authorised service agent).

replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.

Locate the dolly in a suitable work area. Keep area clean and tidy and free from unrelated materials, and ensure that there is adequate
lighting.

Ensure that the floor is level and strong enough (preferably concrete) to take the weight of the dolly and the motorcycle. DO NOT use the
dolly on tarmacadam, as the surface may be unstable.

Keep the dolly clean for best and safest performance.

the maximum motorcycle weight is 565kg. DO NOT exceed this rated capacity.

use appropriate straps to secure the motorcycle to the dolly when manoeuvring.

Pull rather than push the motorcycle when manoeuvring on the dolly to reduce the risk of pushing the motorcycle off its side stand.

Maintain correct balance and footing, DO NOT over reach. Ensure the floor is not slippery and wear non-slip shoes.
 Keep children and unauthorised persons away from the work area.

DO NOT use the dolly for a task it is not designed to perform.

DO NOT use the dolly if it is damaged.

DO NOT use the dolly when you are tired or under the influence of alcohol, drugs or intoxicating medication.

DO NOT allow untrained persons to use the dolly.

DO NOT make any modifications to the dolly.

Before storing in safe area, ensure that all parts are clean and free of grease and oil.
WARNING: The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that may
occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
2.2. Specification:
capacity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 565kg
overall Dimensions (L x W x H). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2120 x 770 x 90mm
Loading track Dimensions (L x W x H). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2000 x 200 x 50mm
Original Language Version
Ms063 Issue: 1 - 27/07/12
2.1. Introduction
Motorcycle dolly holds a single motorcycle or sport bike with side stand, weighing up to 565kgs. Easy manoeuvring around the workshop or
garage. Front and rear lever operated wedge gates allow for easy loading and unloading to the loading track. Includes a five position side stand
platform to fit varied length side stand, front/rear steel pins to keep the motorcycle on the dolly during moving, and smooth rolling dual castor
wheels.
© Jack sealey Limited 2012