Sealey MC550 - Manual (Page 3)

fig.5
5.5 Raising the lift.
CAUTION: DO NOT insert any body parts (e.g., fingers,
arms, etc.) within the interior frame of the Lift while
raising or lowering the Lift.
5.5.1 With the motorcycle tied down securely on the lift, ensure that
the locking bar pin is removed (see fig.2B) so that the safety
locking bar is free to move. see fig.3.
5.5.2 there are three preset heights for the lift depending on which
stop the safety locking bar is engaged at (see fig.2). Pump
the foot pedal until the safety locking bar rides over the
chosen stop position and drops back onto the frame.
5.5.3 Now press the lower pedal (see fig.2B) to allow the lift
to drop slightly so that the safety locking bar is firmly up
against the chosen stop position.
5.6 Lowering the lift.
5.6.1 Pump the foot pedal to raise the lift slightly so that the safety
locking bar is no longer pressing against the stop.
5.6.2 raise the safety locking bar using lever 'c' in fig.2 and lock it
in place with the locking bar pin. (See fig.2B)
5.6.3 Before lowering the lift ensure that there is nothing within the
lift frame that could be damaged by the scissor action of the
descending lift. Ensure that no body parts such as hands,
arms, legs or feet are within the interior frame of the lift.
5.6.4 to lower the lift operate the slow descent pedal and allow the
lift to settle to its lowest position in preparation for removing
the motorcycle.
5.7 Removing the motorcycle from the wheel vice.
5.7.1 With the tie-down straps removed, push down on the handle
bars of your motorcycle, slightly compressing the front
suspension of the motorcycle.
5.7.2 Pull up and back on the motorcycle handlebars.
5.7.3 Keeping your hands on the handlebar, pull the motorcycle
backwards off the lift.
5.8 Storing the lift vertically.
5.8.1 the lift can be stored vertically.
o
WARNING: In this position the lift is not free standing
and must be secured to a wall using a strong chain and a
secure fixing. Failure to adequately secure the lift could
result in serious injury or death in the event of the lift
falling over.
5.8.2 With the lift in its lowest position remove the ramp from the
end of the extended platform. thread the velcro strap
through the guides on the sides of the lift and secure it
around the lift to ensure its stays folded whilst it is being
lifted to the vertical position.
5.8.3 The lift must be raised by two people and will stand on the
two legs and pedal on the wheel chock end. Whilst one
person continues to support the lift the other will secure it in
position using the chain.
5.9 Putting the lift back down for use.
5.9.1 When returning the lift to the horizontal position, equal care is
required to avoid injury to persons. At least two people should
be on hand to support the lift as it is put down for service.
Original Language Version Mc550 Issue: 1 - 02/07/13 © Jack sealey limited
fig.4