Sealey FPS7 - Manual (Page 2)

4. OPERATING INSTRUCTIONS
4.1. Adjusting the Clamps (fig.2).
4.1.1. The upper clamp has 3 locking positions and
the pivot clamp has 2 locking positions. To
adjust the clamps, extract the 'R' clip and
withdraw the pin. Move the clamp to the
desired position, insert the pin and
retain with the 'R' clip.
4.1.2. To obtain the optimum fit for differing sizes of
motorcycle wheel, adjust the positions of the
clamps and then test as necessary.
4.2. Positioning Motorcycle in the Chock.
4.2.1. With the pivot clamp in the open position as
shown in fig.2, align the motorcycle with the
chock.
4.2.2. Push the motorcycle firmly into the chock so
that the front tyre runs through the tapered part
of the pivot clamp.
4.2.3. As the weight of the wheel passes over the
pivot clamp, it will cause the clamp to flip over.
The front of the tyre will be supported by the
upper clamp and the rear of the tyre by the
pivot clamp.
4.2.4. Check that the motorcycle is stable within the
chock before leaving it. If the wheel is loose, or
too high in the chock, extract the motorcycle
from the chock and adjust the positions of
the clamps until the optimum fit is achieved
(see section 4.1.).
4.3. Removing Motorcycle from the Chock.
4.3.1. More effort will be required to remove the
motorcycle from the chock. Ensure that the
space into which the motorcycle will move is
free from obstructions and people.
4.3.2. Take a firm stance and hold the motorcycle
handlebar grips.
4.3.3. Pull back the motorcycle with sufficient force to
overcome the hold of the pivot clamp and
release the motorcycle from the chock.
fig.1
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
email
Original Language Version FPS7 Issue: 1 - 05/07/12 © Jack Sealey Limited 2012
fig.2
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to
www.sealey.co.uk, email [email protected] or phone 01284 757500.