Sealey TPSJK User Manual
Fig.1, Mobile bin storage system joining kit, Tpsjk

InstructIons for:
Mobile bin storage systeM
Joining Kit
MoDEL no's:
tPsJK
thank you for purchasing a sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
1. saFety instrUCtions
IMPORTANT: Please reaD tHese instrUCtions CareFUlly. note tHe saFe oPerational reQUireMents, Warnings &
CaUtions. Use tHe ProDUCt CorreCtly anD WitH Care For tHe PUrPose For WHiCH it is intenDeD. FailUre to Do so May
CaUse DaMage or Personal inJUry, anD Will inValiDate tHe Warranty. Please KeeP instrUCtions saFe For FUtUre Use.
1.1 general saFety
Warning! Ensure Health & Safety, and local authority regulations
are adhered to when assembling and using these storage
system.
Locate storage system in a suitable area where they will not be an
obstruction.
Keep the general area clean, uncluttered and ensure there is
adequate lighting.
Warning! Erect storage system on a level and solid surface
such as concrete.
Keep children and unauthorised persons away from the storage
area.
Do not use the storage system
for any purpose other than that
for which they are designed.
Do not site the storage system out of doors.
Do not get the storage system wet or use in damp or wet
locations or areas where there is condensation.
Do not clean with any solvents which may damage the coated
surface.
Ensure that the storage system is properly assembled before
loading with heavy items.
load for each shelf must be evenly distributed.
Place heavier items lower on the storage system.
Always
push the storage system from the sides, pushing from
the front or back creates a tipping hazard.
2. introDUCtion & Contents
3. asseMbly
fixing kit allows multiple units to be joined together. compatible with
tPs22 and tPs36 to make tPs44 and tPs72.
carefully unpack the product and check the contents against the list
below. should any items be missing or damaged, please contact your
sealey dealer.
Part Description . . . . . . . . . . . . . . . . . . . . . . tPsJK
Double Pin castor . . . . . . . . . . . . . . . . . . . . . . . . 2
upright coupling. . . . . . . . . . . . . . . . . . . . . . . . . . 4
fig.1
two people will be needed to assemble the additional storage
system, part disassembly of the original unit will also be necessary.
4.3 assemble the Double Uprights - tPs72 only
4.3.1 take the frames already made and remove the castor from the
right hand side (front and back) and replace with a double pin
castors from the joining kit.
4.3.2 Install two of the upright couplings on each double upright in
the hole specified as per fig.1B, this will lock the uprights
together.
tap the coupling down with a soft faced mallet.
4.3.3 repeat for second frame.
Original Language Version
tPsJK Issue: 1 - 09/02/11