Sealey SSC11003 - Manual

InstructIons for:
SCREW COMPRESSOR 100ltr 3hp
230V LOW NOISE
moDEL no:
SSC11003
thank you for purchasing a sealey product. manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND
CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY
CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1.5. regularly inspect power supply, leads, plugs and all electrical
connections for wear and damage, especially power
connections, to ensure that none are loose.
1.1.6. Important: the mains voltage must correspond with that
indicated on the electrical data nameplate.
1.1.7. DO NOT pull the powered appliance by the power cable.
1.1.8. DO NOT pull power plugs from sockets by the power cable.
1.1.9. DO NOT use worn or damage leads, plugs or connections.
Immediately replace or have repaired by a qualified electrician.
1.1.10. Products which require more than 13amps are supplied
without a plug. In this case you must contact a qualified
electrician to ensure that a suitably rated supply is available.
We recommend that you discuss the installation of an
industrial round pin plug and socket with your electrician.
Original Language Version
1.1. ELECTRICAL SAFETY
 Make sure the power supply cable is correctly connected
to the earth. It is the user’s responsibility to read,
understand and comply with the following:
You must check all electrical equipment and appliances to
ensure they are safe before using. You must inspect power
supply leads, plugs and all electrical connections for wear
and damage. You must ensure the risk of electric shock is
minimised by the installation of appropriate safety devices.
An rccB (residual current circuit Breaker) should be
incorporated in the main distribution board.
You must also read and understand the following instructions
concerning electrical safety.
1.1.1. the Electricity At Work Act 1989 requires all portable
electrical appliances, if used on business premises, to be
tested by a qualified electrician, using a Portable Appliance
tester (PAt), at least once a year.
1.1.2. the Health & Safety at Work Act 1974 makes owners of
electrical appliances responsible for the safe condition of the
appliance and the safety of the appliance operator. If in any
doubt about electrical safety, contact a qualified
electrician.
1.1.3. Ensure insulation on all cables and the product itself is safe
before connecting to mains power supply.
1.1.4. Ensure that cables are always protected against short circuit
and overload.
SSC11003
1.1.11. If it is necessary to replace a plug on the power supply cable
ensure that the earth wire is connected. All electrical repairs
must be carried out exclusively by a qualified electrical
engineer. Avoid all risks of electric shocks. never use the
compressor with a damaged electrical mains supply cable.
regularly check all electrical cables. never use the
compressor in or near water or near a hazardous area where
electrical shocks may be encountered.
1.1.12. use only extension cables with a plug and earth connections.
the use of too thin an extension cable would result in a
voltage drop and consequent overheating. An extension cable
with a cross-sectional area of 6mm² is recommended.
ssc11003 Issue: 1 - 03/05/13 © Jack sealey Limited