Sealey SA1565 - Manual (Page 4)

Maintenance
Operations.
Weekly. Daily. Monthly. 200 hrs.
drain condensation.
•
check oil level.
•
check guards/covers.
•
check for oil leaks.
•
Replace air filter.
check fittings.
Inspect Pressure Tank.
change pump oil.
check belt tension.
clean air filter.
check safety relief valve.
clean compressor.
check for air leaks.
check for noise or
vibration.
•
•
•
•
•
•
•
•
•
•
5.3. SCHEDULED MAINTENANCE TABLE (NOT ENGINE)
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
email
Original Language Version SA1565 Issue: 2 - 20/02/12
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycle centre and disposed of in a manner which is compatible with the environment.
When the product is no longer required, it must be disposed of in an environmentally protective way.
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to www.sealey.co.uk,
email [email protected] or phone 01284 757500.
5.4. Recommended oils
Synthetic oil suitable for temperatures ranging from -5°c to
45°c: viscosity 5W50. We DO NOT recommend using mineral
oil in this compressor.
Part no. Qty. description
FSO1 1ltr x 12 compressor oil fully synthetic
FSO1S 1ltr x 1 compressor oil fully synthetic
FSO5 5ltr x 1 compressor oil fully synthetic
5.5. IMPORTANT WARNING - Air contaminants taken into the
compressor will affect optimum performance. Example: Body
filler dust or paint overspray will clog the pump intake filter and
may cause internal damage to pump/motor components.
Please note that any parts damaged by any type of
contamination will not be covered by warranty.
6. TROUBLE SHOOTING
Fault Cause Remedy
Pressure drop in the
tank.
Air leaks at
connections.
Run compressor to max.
pressure, switch off.
Brush soap solution over
connections and look for
bubbles. Tighten connections
showing leaks. If problem
persists contact Authorised
Service Agent.
Pressure switch
valve leaks when
compressor is idle.
non-return valve seal
defective.
discharge all tank pressure.
contact Authorised Service
Agent.
compressor stops
and does not restart.
Power failure.
Motor failure.
check electricity supply and
fuse.
contact Authorised Service
Agent.
compressor does
not stop at max
pressure.
Pressure switch fault. contact Authorised Service
Agent.
compressor does
not reach max
pressure.
Filter clogged.
Head gasket or valve
fault.
Replace filter element.
contact Authorised Service
Agent.
compressor noisy
with metallic knock.
low oil level.
Bearing or piston
damage.
Turn off and top up oil
immediately.
contact Authorised Service
Agent.