Sealey LED037 - Manual (Page 2)

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park ,
Bury st. Edmunds, suffolk,
IP32 7Ar
www.sealey.co.uk
W e b
email
Original Language Version LED037 Issue: 1 - 06/03/13
4.1. Keep lamp clean and check for damage before every use. If damage is observed, remove from use until unit is repaired.
4.2. If the lamp fails to operate, disconnect from the battery and check the fuse by pulling the lid off its cover (see fig.1). Replace if necessary, refit
the fuse cover and reconnect to the battery.
4. MAINTENANCE
© Jack sealey Limited
fig.1
3.1. ATTACHING LAMP TO BONNET.
3.1.1. fold the lamp out straight and tighten the thumbwheel. Place the padded hook at the end of the lamp, over one edge of the bonnet, and
gently pull the lamp towards the other side of the bonnet.
3.1.2. steady the lamp with one hand, whilst extending the hook over the other side of the bonnet.
3.1.3. To use the lamp, connect the red (positive) clamp to the battery first, followed by the black (negative) clamp, then turn on using the switch
at the end.
3.1.4 When finished, disconnect the black (negative) clamp first, then the red (positive) one, fold the lamp and store it in a safe, dry and
childproof location.
3. OPERATION INSTRUCTIONS
Environmental Protection.
recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
WEEE Regulations.
Dispose of this product at the end of its working life in compliance
with the Eu Directive on Waste Electrical and Electronic Equipment.
When the product is no longer required, it must be disposed of in an
environmentally protective way. contact your local solid waste
authority for recycling information.