beautypg.com

Ab fig.1 c fig.2 fig.3 fig.4, Introduction & specification 3. operation – Sealey AK437 User Manual

Page 2

background image

2. INTRODUCTION & SPECIFICATION

3. OPERATION

3.1. OPERATION

WARNING! Ensure that you read, and fully understand the safety

instructions before use.

Reminder: This spotlight is designed for intermittent use only. Continuous

use may damage the unit.

1. Charge the batteries before use.

IMPORTANT: Turn off spotlight whilst charging. Failure to do so will

damage the charger plug/vehicle plug.

2. Turn spotlight ‘On’ and ‘Off’ by the rocker switch (fig.3.A) on the main

body.

3. The spotlight has a fixed carrying handle and two adjustable standing

supports (fig.1.C).

3.2. BATTERY CHARGING

WARNING! Ensure that you read, fully understand, and apply the safety

instructions relating to the batteries and charger before use.

IMPORTANT WARRANTY INFORMATION:

The battery pack fitted to this cordless tool is considered to be a consumable item and its ability to

accept charge will reduce over time.

We will warranty it against mechanical and electrical defect for a period of one year - this does not

cover fair wear and tear. If the battery is not properly charged before first use, or regularly

conditioned, its capacity will diminish. Under these circumstances we will not replace the battery pack

even if it is less than one year old.

3.2.1.

Mains Charger plug

1. Ensure the spotlight is turned ‘Off’ and then plug the charger adaptor (fig.2) into the jack inlet

(fig.3.B) on the spotlight body. Stand the spotlight in a safe location ready to charge.

2. Plug charger into the mains supply.

3. Allow approximately 20 hours for the initial charge and 16 hours for

subsequent charges.

4. When full charge has been reached, switch off the mains supply and unplug

the charger from the mains and then from the spotlight. The spotlight is now

ready for use.

5. Store the charger in a safe, dry location.

NOTE: a) Fully charged batteries will last for approximately 30 minutes.

b)

DO NOT fully discharge the batteries before recharging.

3.2.2.

Vehicle Charger plug

1. Ensure the spotlight is turned ‘Off’ and then plug the vehicle charger plug

(fig.4) into the jack inlet (fig.3.B) on the spotlight body. Stand the spotlight in

a safe location ready to charge.

2. Insert the charger plug into the vehicle’s accessory socket (12V only).

3. Allow approximately 20 hours for the initial charge and 16 hours for

subsequent charges.

4. When full charge has been reached, unplug the adaptor from the vehicle’s

accessory socket and then from the spotlight. The spotlight is now ready for

use.

5. Store the charger plug adaptor in a safe, dry location.

NOTE: Charging the spotlight from a 12 volt vehicle socket will drain the vehicle’s

battery, unless the engine is running.

2.1. INTRODUCTION

Weatherproof composite spotlight with carry handle. Integral stand keeps lens and battery case off the floor and permits light to be directed

where it is needed. Ø170mm Lens with halogen bulb produces 5-million candle power of intense white light and is suitable for a variety of

industrial, domestic and leisure applications. Supplied with two sealed 6Volt 4Ah batteries, in-vehicle charger and 230 - 12Volt battery

charger pack.

Weight: . . . . . . . . . . . . . . . . . 3.5kg

Charging Time (approx.): . . . 16hrs

Lens Diameter: . . . . . . . . . 170mm

Operating Time (approx):. . 30mins

Spares:

AK437.V3-01 Bulb - Halogen H3 12V 100W

AK437.V3-02 Switch

AK437.V3-03 Mains Charger 12V 300mA

AK437.V3-05 Battery - 6V 4Ah (x2)

AK437.V3-06 Vehicle Accessory Lead

A

B

fig.1

C

fig.2

fig.3

fig.4

Original Language Version

AK437.V3 Issue: 2 - 18/01/12

This manual is related to the following products: