Sealey LED026EU - Manual (Page 2)

 IMPORTANT WARRANTY INFORMATION:
The battery fitted to this cordless tool is considered to be a consumable item and its ability to
accept charge will reduce over time. We will warranty it against mechanical and electrical
defect for a period of one year - this does not cover fair wear and tear. If the battery is not
properly charged before first use, or regularly conditioned, its capacity will diminish. Under
these circumstances we will not replace the battery even if it is less than one year old.
Note: Fully charge the lamp before first use.
Note: The Lithium battery does not suffer from memory effect and once fully charged may be
stored for up to six months without another charge.
4.1. Connect the charger into the charge socket on the side of the lamp (Fig.1A). Plug into power
supply and turn on, the charging LED (Fig.1B) on the lamp will light RED to show charging
has commenced.
4.2. When the battery has fully charged the LED will turn GREEN.
fig.1
5.1. Direct the lens away from your eyes before switching on. Operate the lamp by pressing the
ON/OFF switch at the rear of the lamp body (Fig.2A). Press the ON/OFF switch once for
NORMAL power and twice for FULL power.
5.2. Suspend the lamp by the hook. When the light is hanging from the hook it can be rotated
through 360° for more precise positioning.
5.3. Alternatively use the integral magnet to attach the lamp to any ferrous metal surface.
fig.2
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal,
drain off any fluids (if applicable) into approved containers and dispose of the
product and the fluids according to local regulations.
WEEE Regulations
Dispose of this product at the end of its working life in compliance with the EU
Directive on Waste Electrical and Electronic Equipment (WEEE). When the
product is no longer required, it must be disposed of in an environmentally
protective way. Contact your local solid waste authority for recycling
information.
Battery Removal
Remove the 6 screws on the back of the lamp. Remove the back casing and
disconnect the wiring to the charger port and from the battery to the circuit
board. Dispose of battery according to local government guidelines.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd
are required to inform potential purchasers of products containing batteries (as
defined within these regulations), that they are registered with Valpak’s registered
compliance scheme.
Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705
4. CHARGING
5. OPERATION
LED026EU Issue: 2(I) - 04/11/14
Original Language Version © Jack Sealey Limited