Fig.3, General instructions – Sealey ML300C User Manual
Page 2
2. gENERAl iNStRUCtioNS
WARNiNg! Ensure the light is disconnected from the mains power supply before attempting any of the following.
3.1.
PoRtABlE lightS
to assemble, remove the thumb screw from the stand and push the end of the stand through the bracket on the bottom of the light.
Align the internal nut in the stand with the hole in the housing and then secure with the thumb screw.
3.2.
BUlB ChANgiNg
WARNiNg! disconnect the light from the power supply and allow to cool before attempting to touch the unit.
do Not touch the new halogen bulb as the natural oil from your fingers will shorten the bulb life. handle with a dry, clean
cloth only.
3.2.1. Loosen the screw on the top of the front cover (fig.3) and undo, allowing the front cover to open. check to ensure that the screw is
retained in the front cover tab (3) by the washer.
3.2.2. remove the old bulb and discard. Hold the new bulb (1) in a clean cloth and insert it (always use the correctly rated bulb).
3.3.3. check that the weather seal is correctly located in the rim (4) and the washer is on the securing screw. close the font cover. seal by
tightening the securing screw.
3.3.
gENERAl
use only original sealey parts for repair or replacement. repairs must only be undertaken by a qualified electrician.
clean the light with a dry, dust-free cloth.
do Not use solvents or abrasives to clean the light.
Avoid touching the glass shield (fig.4.2) as handling may reduce service life and cause the glass to crack. If necessary clean the
shield (when cold) with alcohol and a soft cloth. If the glass is damaged, replace it immediately. use genuine sealey replacement
glass.
do Not use other glass and do Not use the light without the glass shield.
Although weather proof, the light must not be stored wet. should the unit become wet, unplug from mains and wipe dry before storing.
do Not use the light without the weather seal intact.
fig.3
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMPoRtANt: no liability is accepted for incorrect use of this product.
WARRANtY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
iNfoRMAtioN: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK distributor, Sealey group,
Kempson Way, suffolk Business Park
,
Bury st. Edmunds, suffolk,
IP32 7Ar
www.sealey.co.uk
Web
Original Language Version
ML300c.V3 Issue: 1 - 31/12/10