Ultimate Speed UOP 12 A1 - Manual (Page 29)

26 UOP 12 A1
GB
MT
Disposal of the packaging
The packaging protects the device from transport damage. The packaging
materials are selected from the point of view of their environmental friendliness
and disposal technology and are therefore recyclable.
The recirculation of packaging into the material circuit saves on raw material
and reduces the amount of waste generated. Dispose of packaging material
that is no longer needed as per the regionally established regulations.
Operating components
Oil suction pump
2 On/Off switch
3 Positive connection terminal (red)
4 Minus connection terminal (black)
5 Connection for discharge hose
6 Connection for suction hose
7 Suction hose (Ø 6 mm)
8 Discharge hose (Ø 12 mm)
9 Hose clamps
Handling and operation
In this chapter you receive important information for the handling and operation
of the device.
Preparing the oil suction pump
♦ Remove the protective caps from the hose connections 5 + 6 .
♦ Roll out the suction hose (Ø 6 mm) 7 and the discharge hose (Ø 12 mm) 8
and bend them straight.
♦ Press the suction hose (Ø 6 mm) 7 onto the connection for the suction
hose 6 .
♦ Press the discharge hose (Ø 12 mm) 8 onto the connection for the
discharge hose 5 .
♦ Thereby, bear in mind the direction of fl ow (
Pump direction
) given
on the type plate of the oil suction pump .
♦ Secure both hoses with the supplied hose clamps 9 .
TAKE NOTE
► Ensure that the hoses are not kinked or bent, otherwise the hoses and the
pump could be damaged.
IB_75715_UOP12A1_LB5.indb 26 IB_75715_UOP12A1_LB5.indb 26 16.09.13 16:41 16.09.13 16:41