Ultimate Speed Z30544 - Manual (Page 22)

24 GB/MT
Use / Cleaning and Care / Maintenance and storage Safety notes / Use
J Check that all parts have been assembled and
fitted properly and are undamaged.
J Before each use check that the hydraulic vehicle
jack is working properly. Check the screws and
valves of the hydraulic vehicle jack for correct
seating and look out for hydraulic oil leaks in
particular.
J Never use the hydraulic vehicle jack for moving
or loading a vehicle. Never use it to lift a whole
vehicle completely off the ground.
J Make sure that no-one – especially a child – is
in the vehicle and that everyone is kept at an
adequate distance away from the vehicle when
the hydraulic vehicle jack is in use.
J Never change the setting of the safety valve 4 .
It is preset to the correct setting in the factory
and must never be readjusted later.
J Do not use the hydraulic car jack if the sealing
(safety valve
4 ) is damaged.
J If the vehicle jack is damaged, have it repaired
by a suitably qualified person only.
J Under no circumstances carry out any modifi-
cations to the vehicle jack.
J CAUTION! RISK OF SHEARING
AND CRUSHING INJURY! Keep
your fingers away from the area of
the lifting handle socket 3 while pumping.
Failure to observe this advice may result in
shearing and crushing injury.
Q Use
Q Raising the vehicle
CAUTION! RISK TO LIFE! Check that the
vehicle jack and axle stands are in an undamaged
condition before you use them. Ensure that the
hydraulic vehicle jack is used only in combination
with axle stands. Have your axle stands to hand be-
fore raising the vehicle. If you do not use axle stands,
the vehicle may tip over and cause a risk to life.
Follow these steps:
j Ensure that the rod 7 is fully lowered and the
extension screw 2 is completely screwed in
before you put away the vehicle jack.
j Place the hydraulic vehicle jack in the desired
position. In choosing the position, observe the
provisions of the owner‘s manual for your vehicle.
j If necessary screw out the extending screw 2
until it comes into contact with the underside of
the vehicle (Fig. B).
j Connect the rod 7 to the lifting handle 6 to
extend the lifting handle.
J CAUTION! RISK OF SHEARING
AND CRUSHING INJURY! Keep
your fingers away from the area of
the lifting handle socket 3 while pumping.
Failure to observe this advice may result in
shearing and crushing injury.
j Guide the end of the lifting handle 6 into the
lifting handle socket 3 and pump the vehicle
up to the desired height (Fig. C).
j Place the axle stands under the designated
jacking points under the vehicle.
j Relieve the load from the vehicle jack by plac-
ing the rod
7 with the oval opening on to the
release valve 5 , then turning the rod 7 slightly
anticlockwise before turning it back immediately.
The support plate
1 drops slightly and the
vehicle is held on the axle stands.
Q Lowering the vehicle
DANGER TO LIFE! Check that no person or
object is under the vehicle before you lower it.
CAUTION! Lower the vehicle slowly, other-
wise there is the danger of injury and damage
to the product or to the vehicle.
j First raise the vehicle slightly in order to be able
to remove the axle stands. Proceed as described
in the section on „Raising the vehicle“.
j Remove the axle stands.
j Place the rod 7 with oval opening on to the
release valve 5 and turn the rod slowly anti-
clockwise (Fig. A). The vehicle is lowered slowly.
Note: The more quickly the rod 7 is turned
anticlockwise, the faster the vehicle is lowered.
Therefore you should proceed very cautiously
at first in order to get a feeling for the correct
speed.
56310_uls_Wagenheber_Content_LB5.indd 24 10.01.11 14:33