Ultimate Speed 12V CAR ADAPTOR - Manual (Page 31)

33 GB/MT
Note: Make sure that you connect the car adapter in such a way
that the connecting cable can reach as far as the connector sockets
of the cigarette lighter.
Note:
Make sure that the subsurface on which you would like to
mount the car adapter is free of dirt and grease and does not warm
up. You may have to clean the subsurface. A dirty or greasy sub-
surface can reduce the effectiveness of the adhesive pads.
Note:
Mount the car adapter in such a way that it is not subject
to direct sunlight. Otherwise the adhesive strength of the adhesive
pad may diminish.
Remove the protective foil from one side of the adhesive pads.
Place the adhesive pads onto the lower side of the car adapter.
Remove the adhesive foil from the other side of the adhesive
pad.
Place the car adapter on the place you wish to have it and
gently press it down.
Note:
You should only use the product 24 hours after instal-
lation. After 24 hours the adhesive pads have reached their
optimum degree of adhesion. After installation do not change
the position of the adhesive pads. Otherwise the adhesion of
the adhesive pads may be restricted.
CAUTION! DANGER OF ACCIDENT! Check that the car
adapter is still firmly in place at regular intervals.
Using the car adapter
Remove the cigarette lighter from the connector socket.
Plug the 12-Volt connector plug 1 into the connector socket
of the cigarette lighter.
Note: Turn the 12-Volt connector plug 1 if need be so that
18.10.10 13:57