Miomare Basin Spray Shower Attachment - Manual (Page 10)

14 GB
Safety advice
DAN-
GER OF LOSS OF LIFE
AND ACCIDENT TO
INFANTS AND CHILDREN! Never
leave children unsupervised with the
packaging materials. Danger of suffo-
cation. Keep out of the reach of children.
It is not a toy.
Avoid risk of injury
CAUTION! RISK OF INJURY!
Please ensure that no parts are dam-
aged and that all parts are correctly
assembled. Incorrect assembly could
lead to injury. Damaged parts could
adversely affect safety and proper
function.
Do not use the wall mounting 3 for
holding onto or for support. The fasten-
ing materials and the wall mounting
itself are not designed for the loads
which would arise.
DANGER OF SCALDING! When
making the hot water setting please
ensure that the temperature of the
water is not too high.
Avoid damage to property!
The assembly is only to be carried out
by competent persons.
CAUTION! WATER DAMAGE!
Before drilling, ensure that there are no
water pipes where you intend to drill.
Ensure that all seals 7 10 are correctly
seated. Leaks or escape of water can
cause significant damage to buildings
and household contents. All connec-
tions must therefore be checked care-
fully to ensure that they are tight.
Please note that seals are wearing
parts and therefore will require to be
replaced from time to time.
Assembly
Note: with fittings with a M22 external
thread please insert the supplied fitting con-
nection
8 with the adapter piece (M22
internal thread) 9 screwed on, see fig. B.
With fittings with a M24 internal thread
please insert the supplied fitting connection
without the adapter piece (M24 external
thread), see fig. C.
Note: cover each of the parts which are to
be screw connected with a damp cloth or
plastic clips. This will prevent them from
becoming scratched.
Follow these steps:
Hold the wall mounting 3 at the
desired position on the wall and mark
the drill hole.
Drill the hole with a size 6 drill and
insert the dowel 4 in the drilled hole.
Fasten the wall mounting with the screw
supplied 2 (see fig. A).
Screw the fitting connection 8 with the
seal 10 to the fitting (see fig. B / C).
Screw the ½“ connection of the shower
hose 6 with its seal 7 to the thread
opening on the side of the fitting con-
nection
8 (see fig. B / C).
Screw the cone end of the shower
hose 6 with its seal 7 onto the
thread of the washbasin shower 1 .