Miomare Z31166A - Manual (Page 4)

4 GB
Keep all the safety advice and instructions in a
safe place for future reference!
Installation
Installing the tap
Turn off the main water supply to prevent serious
leakage of water. Allow any remaining water
in the pipework to drain.
Install the tap as shown in Figs. A and B.
CAUTION! Do not bend the hoses or place
them under tension. Otherwise material damage
could result.
Attaching the pop-up waste
Install the tap as shown in Fig. C.
Using the pop-up waste (Fig. D)
Press the pop-up waste down to close the waste
and then let water into the sink.
Press the pop-up waste downwards again to open
the waste and allow the water to flow out.
Flushing the tap
The tap must be flushed through before first use
to remove any dirt. To do this, follow these steps
(see Fig. E):
Screw the mixer nozzle 12 off.
Open the main water supply and allow the
water to run for two minutes.
Then screw the mixer nozzle on again.
Operation
Bringing into use
Note: If the tap has not been used for a long period
flush the pipes through thoroughly in order to avoid
stagnation and build-up of residues in the drinking
water supply.
Open the main water supply.
Lift the control lever
13 and swivel it to the right
or left to regulate the strength or temperature
of the water flow.
Hot water:
Swivel the control lever to the left.
Cold water:
Swivel the control lever to the right.
Check that the mixer tap is working properly.
To do this, swivel the lever into all the possible
positions. Please check the connections regularly
for leaks.
Eco-function / saving water
The tap has a water-saving function. This feature
limits the rate of water flow through the tap. The
flow can be infinitely regulated between 0–100 %
by means of a stop.
Turn off the main water supply.
Remove the red / blue hot / cold label 15
carefully by a small flat screwdriver (see Fig. F).
Release the lock screw 14 by turning it anti-
clockwise using a hexagon socket screw key.
CAUTION! Do not take the screw completely
out; just loosen it until the control lever can be
easily taken off.
Take off the control lever.
Loosen the cartridge end ring
16 by hand,
then screw off the cartridge locking ring 17
by using a pipe wrench.
Note: The setting screw 20 for regulating the
water flow is in the lever arm, which projects
from the cartridge (see Fig. G).
To reduce the flow, turn the setting screw anti-
clockwise. This limits the movement of the lever
arm and therefore the movement of the control
lever as well. The flow is reduced as the control
lever now cannot be lifted quite so high.