Miomare Z30397A Z30397B - Manual (Page 5)

5 GB
with the metal nuts 6 . Use the wings for the
nuts 7 as a tightening aid.
Inserting and replacing
batteries
Before first use, open the battery box 10 using
a Phillips screwdriver (not included).
Insert 2 x 1.5 V AA batteries (Model
Z30397 A) or 3 x 1.5 V AA batteries
(Model Z30397B) into the battery box
10 .
Note: Make sure you fit the batteries the right
way round (polarity). The correct orientation is
shown in the battery box
10 .
Close the battery box 10 and fasten it using
the Phillips screwdriver.
Creating the electrical
connection
Remove the silicone cap 9 and put it away in
a safe place.
Insert the plug 12 of the battery box 10 into
the socket on the toilet seat 8 (see Fig. D).
Check that the plug 12 is securely inserted into
the socket.
Open the lid of the toilet seat 8 and press the
ON / OFF switch 13 on the battery box 10 to
switch on the LED light (see Fig. D).
Close the lid of the toilet seat 8 or press the
ON / OFF switch 13 on the battery box 10
again to switch off the LED light.
Note: Leave the ON / OFF switch 13 in the
OFF position if you do not wish to use the LED
function.
Fastening the battery box in
place (see Fig. E)
Pull off the protective foil from the back of the
pile and loop fastening strip
11 and stick the
strip on to the battery box 10 .
Pull the second protective foil from the pile and
loop fastening strip
11 and stick the battery
box 10 in the desired position on the wall or
other surface.
Now you can take the battery box 10 off the
wall at anytime by separating the two parts of
pile and loop fastening strip.
Note: Do not use the product for the first
24 hours after installation to allow the adhesive
on the pile and loop fastening strip
11 to
achieve its full bond strength. Once fixed in
position, do not pull the pile and loop fastening
strip from the supporting surface. The adhesive
foil could lose its ability to stick.
Cleaning and Care
Do not under any circumstances use corrosive
or abrasive cleaning agents. Otherwise the
surface of the product can be damaged.
Use a slightly moist, fluff-free cloth when you
are cleaning or polishing the product.
Before doing any cleaning of the product,
place the silicon cap
9 into the socket of the
toilet seat to prevent water from entering.
Troubleshooting
Note: This product contains sensitive electronic
components. It may therefore malfunction in the
vicinity of devices that emit radio signals.
If an electrostatic charge builds up on the product, it
may cause the product to stop working. If this occurs,
briefly remove the batteries and then reinsert them.
Disposal
The packaging is made entirely of
recyclable materials, which you may
dispose of at local recycling facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.