Efficient Networks SpeedStream 5600 Series - Manual (Page 28)

Efficient Networks, Inc. How do you want to use the Router? 27
4 Select Max as the rate.
5 Enter an IP address and netmask to use for the DSL/WAN interface.
6 Select Modify VC .
7 Select the “ Advanced Setup ” button in the top left panel.
8 Select the “ Command List ” button in the top left panel.
9 From the command list on the left, select “ipgateway”.
10 Enter the “ Enter new IP address ” field, enter the IP address of an IP
gateway (default route) that is on the same subnet as the router.
11 When the response appears at the bottom of the screen, it will have
link that says “REBOOT REQUIRED”. Click on that link and reboot
the router. Select
Refresh after a minute or two to see the new
configuration.
Bridge Configuration
The first thing you must do to use the 5600 series router as a bridge is
change it to bridge mode.
To change mode from the HTML interface:
1 On the first page, select Change to Bridge Mode” .
2 When the display appears, select the radio button labeled Bridge .
3 When the response appears at the bottom of the screen, it will have
link that says “REBOOT REQUIRED”. Click on that link and reboot
the router. Select
Refresh after a minute or two to see the new
configuration.
The only other possible configuration parameters you may need to set
would be the VPI/VCI numbers as specified by your service provider.
When the unit comes back up in bridge mode, select the
Simple Setup
link to configure it.