Efficient Networks SpeedStream 5600 Series - Manual (Page 14)

Efficient Networks, Inc. Installation Instructions 13
RJ45 Connector Information
The pinout of the router’s Category 3 and 5
UTP jack is different than a standard Ethernet
UTP jack.
Ethernet loopback connectors will not work
on the port and vice versa.
Once the connector is
plugged into a board that is installed in a chassis,
the removal lever on the connector may be hard to
reach. Do not try to pull the connector out of the
port without pushing up on the removal lever.
RJ11 Connector Information
The router comes with an RJ11 jack that uses pins 3
and 4. Optionally, the router may be configured to
use pins 2 and 5. If so, the markings on the outer
casing of the unit will indicate this.
Router LEDs on Startup
The router is equipped with four LEDs on the front panel: the System
LED (
sys ), Ethernet LED ( enet ), ATM LED ( atm ) and DSL LED ( dsl ).
1 First, all four LEDs light up red for a moment as the hardware
initializes. Then, the
sys LED turns solid yellow and then solid green
when the unit has finished passing diagnostic tests.
2 The dsl LED will flash green while the DSL line is training to obatin
the optimum transmission rate. If a DSL link cannot be established,
the LED will flash green and yellow. When the line is trained, the
LED turns solid green.
12 345
678
Transmit +
Transmit –
Receive –
Receive +
RJ45 Connector
removal
lever
RJ11 Jack
1 2 5 6 3 4
Pinout