Florabest FLB 3000 A1 - Manual (Page 7)

6
GB
Content
Illustrations A-D
Introduction 6
Intended use
6
Scope of deliverables 6
Description of product 6
Unpacking 6
Technical Specifications 7
Safety symbols
7
General safety instructions 8
Training 8
Preparation 8
Operation 8
Maintenance and storage 8
Safe operation 9
Personal safety 9
Careful handling of tools 9
Special safety instrucions leaf blowers/vacuums 10
Preparing of the blower vac prior to use 11
Assembly 11
Intake/ Air outlet tube 11
Fitting the debris collection bag 12
Fitting the shoulder harness 12
Before starting 12
Operation 12
Starting the Vacuum-Blower 12
Stopping the Vacuum- Blower 12
Using the Vacuum-Blower 12
Blower mode 12
Vacuum mode
12
Adjust the front handle 13
Using the leaf rake 13
Cleaning flap 13
Cleaning and Storage 13
Power Cord Maintenance 13
Troubleshooting 13
Waste disposal and environmental protection 14
EC Declaration of Conformity 14
Guarantee 14
Repair service
15
Spare parts 15
Warranty card 16
Explode drawing 88
Introduction
Congratulations on the purchase of your new device.
You have chosen a high quality product. The operating
instructions are a constituent part of this product. They
contain important information for safety, operation
and disposal. Familiarise yourself with all operating
and safety instructions prior to using the product. Use
the product only as described and for the areas of
application stated. If the device is passed on to a third
party then pass all of the documentation on with it.
Intended use
The leaf vac is exclusively used in the two fol-
lowing ways:
1.As a leaf vac for vacuuming up dry leaves.
2.As a blower it is used to collect together dry leaves
or to remove them from inaccessible places (e.g.
under vehicles).
In suction mode it also works as a shredder, where
the volume of the leaves is reduced by a ratio of
approx. 15:1 and takes up less space in the leaf
collection bag and the collected material is simulta-
neously prepared for possible composting.
Each type of use other than those given in these
instructions for use can damage the machine
and cause serious risk to the user.
Please always observe the safety instructions in order
to safeguard your guarantee claim and in the interests
of product safety. Due to the machine’s design, we are
unable to fully exclude all residual risks.
Scope of deliverables
Description of product (Fig. 1)
1 Motor housing
2 Adjusting speed controller
3 ON/OFF-Switch
4 Power cord & plug
5 Selection knob
6 Wheel
7 Lower tube
8 Upper tube
9 Collection bag
10 Cable strain relief
11 Screw plug
12 Cleaning flap
13 Front handle
14 Shoulderbelt
15 Operating Instructions
Unpacking
Due to modern mass production techniques, it
is unlikely that your power tool is faulty or that