Florabest FGH 710 A1 - Manual (Page 46)

46
GB
parts before using it. Check that all
nuts, bolts, and screws are tight.
• Check the covers and guards for dam-
age and correct fit. Change them if
necessary.
We shall not be held responsible for any
damage caused in any of the following
ways:
- Improper repair
- Use of non-original parts
- Use other than for the intended pur-
pose
Changing the tines
The tool is fitted with four tine wheels that
can easily be changed in pairs. Both of the
tine-wheel pairs can be fitted on the left or
right, as required.
Always change both tine pairs
at the same time to avoid dam-
age to the tool from imbalance.
Switch the tool off, unplug it and
wait for the tines to stop turning.
D
1. Unscrew the hex bolt (19) and the
self-locking nut (20) on the tine-
wheel pair (11).
2. Slide the tine-wheel pair off the
shaft (10).
3. Clean the driveshaft
with biological oil.
4. Slide the new tines onto
the driveshaft with the
holes on the axles
aligned to the holes on
the driveshaft (21).
Make sure that the tines are set to
their proper turning direction. The
arrows on the gearbox and tines
should point the same way
( D No. 22).
5. Slide the hex bolt through the
hole and tighten on the self-lock-
ing nut (supplied with each new
tine wheel pair 23).
Storage
• Leave the motor to cool down before
you put the tool into a closed space.
• Keep the tool clean, dry and out of the
reach of children.
• Do not cover the tool in plastic bags as
moisture may form.
E
Unscrew the wing nuts
and fold the fork grips down to reduce the
space taken by the tool.
Make.sure.that.the.cable.does.not.
become.jammed.
• The frame tubing also serves as a hook
to hang up the tool at the place of stor-
age.
Do not use the tool with the
handle folded closed.
Replacement parts
Use the service address or fax number
supplied to order replacement parts. Make
sure you include the order number in your
order.
Set of tines
Right/left ............... Order No. 30261000
Please contact our service address for all
other replacement part numbers.