Florabest FHL 900 A1 - Manual (Page 16)

16
GB
Warning:
The vibration emission value may differ
during actual use of the power tool from
the stated value depending on the manner
in which the power tool is used.
Safety precautions aimed at protecting
the user should be based on estimated
exposure under actual usage conditions
Trouble Shooting
Problem Possible cause Fault correction
Device does not start
Mains voltage not on
Check plug socket, cable, line
and plug, where appropriate,
have repaired through electrical
specialist
On/Off switch defective
Repair by Service Centre Worn carbon brushes
Defective motor
Device runs with inter-
ruptions
Power cable is damaged
Check the cable and have it
changed by the Service Centre if
necessary
Internal loose electrical
connection Repair by Service Centre
On/Off switch defective
Blades become hot
Blades are blunt
Have the blades sharpened or
replaced (Service Centre)
Blades are notched
Have the blades checked or
replaced (Service Centre)
Too much friction due to lack
of lubrication
Oil the blades
(all parts of the operating cycle are to be
considered, including, for example, times
during which the power tool is turned off
and times when the tool is turned on but is
running idle).