Florabest FGH 710 A1 - Manual (Page 8)

8
IE GB
The major functional parts
are shown on the foldout
pages.
Functional parts
A 1a Right-hand fork grip with dead-
man lever, safety release catch
and cable tension relief
1b Left-hand fork grip
2 Mains cable
4 Plastic cross-plate
5 Two central tubes
6 Frame tubing
3a Large cable clip
3b Small cable clip
7 Vent
8 Motor housing
9 Gearbox
10 Driveshaft
11 Tines
12 Belt clip
Intended purpose
The tool is intended for breaking up and
tilling coarse soil for the purpose of mixing
in fertiliser, peat and compost in domestic
areas.
Any use other than that specifically
named in this manual may lead to dam-
age to the tool and represents a serious
injury hazard for the operator.
The operator or user of the tool is respon-
sible for any damage or injury caused to
other persons or property.
This tool is intended for use by adults.
Children and persons unfamiliar with the
manual must not be allowed to use the
tool. Do not use the tool in rain or damp
surroundings.
The manufacturer shall not be held liable
for damage arising from improper use or
incorrect operation of the tool.
Assembly instructions
Always disconnect the tool from the
mains before conducting any work
on it.
Scope of delivery
Carefully remove the tool from the pack-
aging and check that the following parts
are complete:
• Motor housing with tines and frame
tubing
• Right-hand fork with dead-man lever
and permanently fixed mains cable
• Left-hand fork grip
• Plastic cross-plate with cable guide
• Assembly tools, cable clips and belt
clip
• User manual
While assembling the tool, make
sure that the mains cable does not
become caught and has enough
slack.
Fitting the grip tubing
B 1. Push the two fork grips (1a/1b)
into the plastic cross-plate (4),
and screw the plate into the cor-
responding holes in the grip tub-
ing from behind using the bolts
provided (13).
2. Screw both central tubes (5) onto
the fork handles (1a/1b). To do
this, push the enclosed screws
(14) inwards through the holes
from the outside and screw them
in place with the wing nuts (15).
3. Position the handle rod with the
pipe ends to the left and right on
the lower frame tubing ( A 6)
and screw it in place with the en-
closed screws (14) and wing nuts
(15).