Florabest FGH 710 A1 - Manual (Page 10)

10
IE GB
Cleaning, maintenance,
storage
Warning! Always return the tool
to the service centre for work not
described in the manual. Only use
original parts.
Switch the tool off, unplug it from
the mains, and wait for the tines to
stop moving before carrying out any
maintenance or cleaning work on
the tool.
Perform regular maintenance and clean-
ing on the tool. This will ensure long, reli-
able service.
General cleaning and mainte-
nance work
Do not spray the tool down with wa-
ter (especially not under pressure),
and do not clean it under running
water.
Wear protective gloves when carry-
ing out maintenance and cleaning
work on the tool to avoid injury from
cuts.
Always clean the tool thoroughly after
each use. Always keep the tool clean.
Do not use cleaning fluids or solvents.
• Remove any soil and dirt residues
stuck to the tines, driveshaft, tool
surface and vents with a brush or dry
cloth.
• Spray or rub biodegradable oil into the
tines.
• Clean soiled grips with a damp cloth.
• Always check the tool for obvious
damage such as loose, worn or dam-
aged parts before using it. Check that
all nuts, bolts, and screws are tight.
• Check the covers and guards for dam-
age and correct fit. Change them if
necessary.
We shall not be held responsible for any
damage caused in any of the following
ways:
- Improper repair
- Use of non-original parts
- Use other than for the intended pur-
pose
Changing the tines
The tool is fitted with four tine wheels that
can easily be changed in pairs. Both of
the tine-wheel pairs can be fitted on the
left or right, as required.
Always change both tine pairs at the
same time to avoid damage to the
tool from imbalance.
Switch the tool off, unplug it and
wait for the tines to stop turning.
D
1. Unscrew the hex bolt (19) and
the self-locking nut (20) on the
tine-wheel pair (11).
2. Slide the tine-wheel pair off the
shaft (10).
3. Clean the driveshaft
with biological oil.
4. Slide the new tines onto
the driveshaft with the
holes on the axles
aligned to the holes on
the driveshaft (21).
Make sure that the tines are set to
their proper turning direction. The
arrows on the gearbox and tines
should point the same way
( D No. 22).