Encore electronic 802.11n - Manual (Page 8)

The Rear Panel
The rear panel of the Wireless Router is shown below.
Power Connection
Plug the circle end of the power adapter firmly into the rear panel of the Wireless Router,
and the other end put into an electric service outlet then the system is ready.
Restore Default Button
1. Push the button for more than 5 seconds and then release it, the system will return
to factory default setting. In the meantime, system rewrites flash to default value and
Status LED halts for a while. Approximately 60 seconds later, the Status LED blinks
green periodically, now the whole system parameters have returned to factory
default value. If the process has been interrupted by any reason (power off…), the
system will fail. Before performing the process, ensure a safe operating environment
please!
2. To reboot the Router, press the button for 2-5 seconds and then release it, and all
the setting won’t be erased. Wait for the Router to complete the reboot, and then
you can start to use it.
Warning： Incomplete factory setting recovery procedure will cause the Wireless Router
malfunction！If you are unfortunately in this situation, do not try to repair it by
yourself. Consult your local distributor for help!
4