Florabest FRT 450 A1 - Manual (Page 10)

10
GB
the motor head (7) (see applica-
tion position ).
Ensure that the cutting strings
are not clamped in.
4. Secure the protection cover (8)
with the 3 cross recessed screws
included in delivery.
. . Dismantling.the.spacer:
5. In order to remove the spacer,
unscrew the 3 cross recessed
screws on the protection cover
(8) and remove the spacer (10).
6. Remount the protection cover
(8).
. . Mounting.the.additional.handle:
1. Unscrew the screw (11) on the
additional handle included in de-
livery (12).
2. Pull the ends of the additional
handle (12) apart and push this
over the handle holder (16).
3. Screw on the additional handle
(12) using the screw (11).
Operation
. WARNING:.Danger.of.injury!.
Never.use.the.trimmer.without.its.
protective.cover..Always.check.
the.operability.of.the.trimmer.
before.it.is.used..Check.that.the.
mains.voltage.is.the.same.as.
indicated.on.the.rating.plate..Al-
ways.wear.goggles.when.work-
ing.with.the.trimmer.
Please observe local regulations
concerning noise protection.
Switching ON and OFF
1. Remove the protection card-
board packaging on the line cut-
ter ( .13).
2. Form a loop in the end of the ex-
tension cable, conduct it through
the opening in the upper handle
(1) and hang it on to the strain
relief (4).
3. Connect the trimmer to the
mains socket.
4. Ensure a secure stand and
hold on to the trimmer with both
hands. Do not deposit the cutting
head on the ground.
5. To switch on depress the ON
/ OFF switch (2). Release the
switch to switch off.
After the trimmer has been switched
off the cutting head will continue
to rotate for a few seconds. Keep
hands and feet well away.
. The.ON./.OFF.switch.must.not.
be.locked.in.place..The.trimmer.
must.not.be.used.if.the.switch.is.
damaged..There.is.the.immedi-
ate.danger.of.injury.if.the.motor.
does.not.switch.off.after.the.ON./.
OFF.switch.has.been.released.
Caution: Always remove grass
residue from the line cutter so that
the cutting effect is not impaired.
Trimmer settings
Adjusting.the.additional.handle:
The additional handle can be set in dif-
ferent positions. Set the handle in such a
manner that the cutting head is slightly tilt-
ing forwards when in the working position.