Florabest FLV 1300 A1 - Manual (Page 49)

49
MT GB
3. Hang the cable strain relief
(19a) on the upper handle bar
(4).
Attach the clip ring to the ten-
sion adjuster bracket (19b) be-
neath the cable tension adjuster
(19a) on the upper handle (4).
4. Use the screws and wing nuts
(5b) to firmly secure the upper
handle bar (4) to the two centre
bars (15).
5. Fasten the electric cable (16)
to the bar with the two cable
clamps (14a+b).
Mounting and emptying the
collection bag
WARNING: Never operate the
implement without the impact
protector. Danger of Injury!
Assembling the collection bag:
The collection bag is delivered in a folded
state and must therefore be assembled
before it is mounted on the implement.
C 1. Assemble the collection bag
rods (22).
2. Slip the plastic straps (24) over
the collection bag rods.
Mounting the collection bag
on the implement:
3. Lift the impact protector (9).
4. Push the pins on the collection
bag rods (23) into the socket in
the implement case (10).
5. Release the impact protector so
that it holds the collection bag
(6) in its position.
Removing and emptying the
collection bag:
6. Lift the impact protector (9) and
take out the collection bag (6).
Operation
Please observe local regulations
concerning noise protection. It is
quite possible that local rules and
regulations may limit the time of
implement operation or even pro-
hibited its use on certain days (e.g.
Sundays and holidays), and dur-
ing certain times of the day (noon,
night hours) and in certain areas
(e.g. spars, clinics, etc.).
Setting the working positions
The implement has 5 principal position set-
tings:
Setting 0 : Transport position
This position sets the maximum safety
spacing between the tool and the floor.
Setting 1 : Working position
Set this position when working with a new
implement.
Settings 2 - 4 : Readjustment posi-
tions
The working position can be lowered with
increased knife and sprung tine wear.
Wear can be identified from an increas-
ingly poor result.
The readjusting depth amounts to approx.
3 mm per setting. Use the millimeter scale
readings for fine setting.
When the implement is delivered
it is in the Transport Position 0 set-
ting.
The implement must be switched off to
set the working position. Press the setting
button
(see A No. 13) down and turn it to the
required position until it locks in place (the
button immediately rises again).