Florabest FGS 10 A1 - Manual (Page 57)

57
Gb Mt
have been packaged sufficiently and
which have been dispatched with cor-
rect stamping.
• note: In case of complaint or service,
please deliver your device cleaned,
and with an indication of the defect, to
our service address.
Devices sent in freight collect - by
bulk freight, express or with other
special freight - are not accepted.
• Defective units returned to us will be
disposed of for free.
Technical data
Unit
Motor voltage ................................9.6 V
Protection class ..................................... III
Protection category............................IPX0
Grass-trimming blades
Width of blades .......................... 100 mm
Shrub-trimming blades
Length of blades ........................ 200 mm
Distance between teeth...........ca. 8 mm
Weight (without recharger) ............1.32 kg
Sound pressure level
(L
pA
) .................. 83 dB(A), K
pA
=2.0 dB(A)
Sound power level (L
wA
)
guaranteed .............................. 86 dB(A)
measured ......84.3 dB(A); K
wA
=1.5 dB(A)
Vibration (a
n
)
at handle ..............3.27 m/s 2 , K=1.5 m/s 2
battery (niMH)
Nominal voltage ..................9.6 V 1.3 Ah
Loading time ............................ max. 5-8 h
recharger .................................. SI-12045
Uptake voltage................... 230 V~, 50 Hz
Nominal consumption .......................12 W
Voltage output....................................12 V
Recharging curren ........................ 450 mA
Performance output ........................5.4 VA
Protection class ................................. II
Protection category............................IPX0
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Safety precautions aimed at protecting
the user should be based on estimated
exposure under actual usage conditions
(all parts of the operating cycle are to be
considered, including, for example, times
during which the power tool is turned off
and times when the tool is turned on but is
running idle).
The noise and vibration levels have been
calculated according to the norms stated
in the conformity statement.
Technical and optical alterations to serve
progress may be made without notice.
All measurements, instructions and other
data given in this manual are therefore
given without guarantee of correctness.
Legal claims made on the basis of this
manual are therefore excluded.