Crivit SL-1530 - Manual (Page 39)

39
6 . Turn the ratchet over to tension the balance
band .
7 . Pull the safety catch (S) upwards to release the
ratchet . Move the ratchet catch (R) towards
the balance band, then move it in the opposite
direction to tension the balance band .
IMPORTANT: The band must be
wrapped at least one and a half times
but no more than two and a half
times around the shaft. Only tension
the band as much as possible with
normal manual force. Never use a
power booster!
3 . The storage bag is also the protective cover .
Open the strap of the protective cover at each
side and pull the protective cover out over
the ratchet . Do not pull the protective cover
completely over the ratchet until the slackline is
tensioned .
4 . With the ratchet closed, feed the balance band
through the slit in the shaft .
5 . Pull the balance band as far through as pos-
sible, until it is taut .
GB