Preparing for use – Crivit Z31037 User Manual

Page 35

GB/MT

Setting training duration:
1. Press the SET button

, until the ﬁgure in the T box

(time) on the LC display

ﬂashes.

2. Enter the desired training duration in minutes (1–60) by

means of the UP

and DOWN buttons

3. Press the SET button

again to conﬁrm the set training

duration. The desired training duration appears in box T.

Note:

if a training duration has not been set, then the

computer measures the training duration automatically.
At the training start the reading is 0. At the end of train-
ing the reading stops automatically.

Note: in order to save the battery, the skipping rope computer
switches itself oﬀ automatically after approx. 8 minutes, in
which there has been no rope movement or pressing of any
buttons. You must then enter your body weight (W) and
desired training duration (T) again.

Training:
1. Begin the training. The computer starts automatically.
2. The LC display shows

– the set body weight in box W,

– the remaining / counting training duration in box T,

– the number of skips / rope revolutions in box L

(from the 6

skip onwards),

– the calorie consumption in box C.

Note: you hear an acoustic signal as soon as the set train-
ing duration has elapsed and the computer then stops auto-
matically. The current values ﬂash up in the LC display

Note: press the RESET / ON button

to delete the set

body weight and the set training duration, or to reset to the
factory setting.

Preparing for use