Cortez – Kichler 300113 User Manual

Page 9

Cortez

Fig. 18

Fig. 19

10. INSTALLING THE MOUNTING PLATE

Step 2. Place the key holes on the mounting
place over the 2 screws previously loosened
and turn the mounting plate until it locks in
place at the narrow end of the key holes.
Secure by tightening the 2 screws previously
loosened and reinstall the one removed.
(Fig. 18)

Step 1. Remove 1 of the 3 screws in the
mounting ring and loosen the other 2
screws, do not remove (The mounting ring
located on the motor shaft).

11. INSTALLING THE SWITCH HOUSING

NOTE: Before continuing, make sure the
power is disconnected by turning off the
circuit breaker of removing the fuse at the
circuit box.

NOTE: If you plan to install an “Optional”
light fixture purchased separately, please
skip to step 13 and continue. If you want
your ceiling fan installed WITHOUT an
“Optional” light fixture, follow steps below
and then skip number 13 on the next page.

Step 1. Remove 1 of the 3 screws on the
edge of the mounting plate and loosen the
other 2 screws, do not remove.

Step 2. The square plastic wiring connector
from the ceiling fan and the switch housing
will only fit together one way. Match up the
color on the side of each connector, then
push them together until the snap engages.

Step 3. Tuck the new connection neatly into
the switch housing. Align the key holes on
the switch housing with the 2 screws on the
mounting plate. Turn switch housing until it
locks in place at the narrow end of the key
holes. Tighten the 2 screws and reinstall the
third screw, making sure all three are tight
and secure. (Fig. 19)

Mounting Plate

Screw

Mounting Plate

Switch Housing