Kichler 300113 - Manual (Page 5)

4 Corez
TM
5. HANGING THE FAN
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly:
Step 2. Secure the hanger bracket to the
ceiling outlet box using screws and washers
provided with the outlet box. (Fig. 6)
Step 4. Loosen the two set screws and
remove the hitch and lock pin from the motor
coupling assembly. (Fig. 8)
Step 1. Remove the down housing, upper
glass bowl and motor from the protective
plastic bag and take the lower Styrofoam
packing pad out of the carton. Place the
Styrofoam pad on the floor, then place the
motor into the Styrofoam pad with the
bottom of the motor facing up. (The Styro-
foam pad serves as a holder for the fan
during the first stages of assembly).
Remove the plastic motor shipping blocks
and discard. (Fig. 5) Install the motor into
the down housing with the screws provided.
Step 5. Carefully feed fan electrical wires up
through the downrod. Thread the downrod
onto the motor coupling until the hitch pin
holes are aligned. Next, replace hitch pin and
lock pin, and tighten both set screws. (Fig. 8)
Fig. 7
Fig. 5
Fig. 6
Fig. 8
Lock pin
Downrod
Supply wires
Hitch pin
Mounting bracket
Mounting screw
Washer
CUL listed electrial box
120 V wires
Set Screw
Cross Pin
Hanger Ball
Downrod
Down Housing
Screw
Motor
Step 3. Use a screwdriver to loose the safety
cross pin and remove it from downrod assem-
bly. Loose the set screw and rotate the hanger
ball off the downrod. (Fig. 7)