Kichler 300113 - Manual (Page 8)

7
Fig. 15
Fig. 16
Fig. 17
8. INSTALLING THE CEILING CANOPY
Canopy Cover
Canopy
Screw
Hanger bracket
Outlet box
Step 1. Attach the blade to the blade bracket
using the screws, washers and fiber washers
provided. Refer to Fig. 16 as needed. Start each
screw into the bracket.Repeat for the two
remaining screws.
Step 2. Make sure the blades is straight and
tighten each screw until the fiber washer is
slightly compressed and all three screws are
secure.
Step 3. Attach each completed blade assembly
to face of the motor using “pre-installed” mount-
ing screws in each blade bracket. (Fig. 17) Make
sure each mounting screw is securely tightened.
Screw
Metal Washer
Fiber Washer
Blade
Blade Bracket
Blade
Blade Bracket
Screw
Step 2. Slide the canopy up to ceiling and onto
the two screws on hanger bracket. Rotate the
canopy clockwise and tighten the two screws.
Next, while holding the canopy with one hand,
slide the canopy décor over the screws and
rotate clockwise until tight.
Step 1. Make sure all of the electrical connec-
tions are tucked neatly into ceiling outlet box.
WARNING: One last time, make sure the
“Check Tab” at the bottom of the hanger bracket
is properly seated in the “Registration Slot” on
the side of the hanger ball before attaching the
canopy to the bracket. Failure to properly seat
the “Check Tab” could damage the electrical
wires when to ceiling fan blade direction is
changed while the fan is running.
NOTE: You may need to adjust the canopy
mounting screws as necessary until the canopy
and canopy cover have a snug fit. (Fig. 15)
9. ASSEMBLYING AND ATTACHING
THE FAN BLADES