Kichler 300113 - Manual (Page 7)

6
Cortez
TM
6. INSTALLATION OF SAFETY SUPPORT
( For Canadian Installation ONLY )
7. MAKE THE ELECTRIC CONNECTIONS
A safety support cable is provided to help
prevent the ceiling fan from falling, please install
it as follows.
Step 1. Attach the provided wood screw and
washers to the ceiling joist next to the mounting
bracket but do not tighten. See Figure 13-1
Step 2. Adjust the length of the safety cable to
reach the screw and washers by pulling the
extra cable through the cable clamp until the
overall length is correct, put the end of the cable
back through the cable clamp, forming a loop at
the end of the cable. Tighten the cable clamp
securely. Remove the excess safety cable.
Now, put the loop in the end of the safety cable
over the wood screw and under the washers.
Tighten the wood screw secuely. (Fig. 13-2)
Fig. 14
Blue (for light)
Black
("to motor L")
Black (hot)
Outlex box
White (neutral)
Green or bare
copper (ground)
white ("to motor N")
Ground -(Connect to
(green) ground wire on
if no house ground
hanger bracket
wire exists)
Fig. 13-1
Fig. 13-2
Safety Cable Cable Clamp
Wood Screw
Wood Screw
Outlet Box
Ceiling Joist
Ceiling
3 mm(1/8")
WARNING: To avoid possible electrical shock,
be sure the electricity is turned off at the main
circuit breaker of fuse box before wiring.
WARNING: If your house wires are different
colors than referenced in this manual, stop
immediately. A professional electrician is
recommended to determine proper wiring.
ALL electrical connections should be made
with the supplied WIRE NUTS. Make sure
each connection below is tight and secure.
Step 1. Connect the fan supply BLACK wire
and fan light supply BLUE wire to the BLACK
housedhold supply wire as shown in Fig. 14.
Step 2. Connect the fan neutral WHITE wire to
the household neutral WHITE wire as shown in
Fig. 14.
Step 3. If your outlet box has a ground wire
(GREEN or bare COPPER) connect it to the
fan ground wire (GREEN); otherwise, connect
the ground wire on the hanging bracket to the
fan ground wire (GREEN).
WARNING: Be sure no bare wire or wire
strands are visible after making all connec-
tions.
Step 4. After making all of the above connect-
ing, spread them apart so the GREEN and
WHITE wire connections are on one side of
the outlet box and the BLACK and the BLUE
wires connections are on the other side. Now,
push the completed connections upward into
the outlet box.